15. Hal.N North pole Hall sensor mapping
Specifies which parameter the detected south pole magnetic field strength should map to;
- 'Off'; the sensor will not respond to a magnet for this polarity
- 'Fltr'; magnet proximity will cause filter to close for this polarity
- 'FLFO'; magnet proximity will cause filter LFO to modulate filter cut-off frequency for this polarity
- 'PLF.1'; magnet proximity will allow pitch LFO 1 to modulate for this polarity
- 'PLF.2'; magnet proximity will allow pitch LFO 2 to modulate for this polarity
- 'PL.1.2'; magnet proximity will allow pitch LFO 1 and 2 to modulate for this polarity
- 'Vol'; magnet proximity will cause volume to decrease
- 'ALF.1'; magnet proximity will allow amplitude LFO 1 to modulate for this polarity
- 'ALF.2'; magnet proximity will allow amplitude LFO 2 to modulate for this polarity
- 'AL.1.2'; magnet proximity will allow amplitude LFO 1 and 2 to modulate for this polarity
You may also be interested in...
- 16. L2.Ho LFO 2 Hold (under Pitch page)
- 16. L.C.ho hold duration for cutoff frequency LFO (under Filter page)
Specifies the hold duration in milliseconds for which the LFO should hold the LFO's sampled value.
- 11. L1.rt LFO 2 rate (under Pitch page)
Specifies the rate (in steps) in which the LFO should complete a cycle.
- 9. L1.Wv LFO 1 Waveform (under Pitch page)
- 6. LF.rt (under Filter page)
'rand' will start the LFO at a random phase (location in the chosen waveform).